The tag printers print to very small paper. Therefore, The Edge allows you to adjust printer settings to ensure proper printing on the tag.
Center Adjustment |
Allows you to adjust the center space between ends of the dumbbell tag. |
Left Edge Adjustment |
Allows you to adjust the left edge of the label. Bigger is more to the right. |
Number of Retries to Open Port |
The number of times to retry opening the printer port before showing an error. |
Port Number |
The tag printer port, e.g., LPT1. |
Special Strings to Begin Batch Print |
Special strings to send before a batch of tags. Not supported by all tag printer models. Might override other settings. |
Special Strings to End Batch Print |
Special strings to send at the end of a printer batch. Not supported by all tag printer models. |
Special Strings to Send on Individual Tag Print |
Special strings to send before each tag. Not supported by all tag printer models. |
Tag DPI |
The dots-per-inch capability of tag printer 1. |
Tag Printer Burn Settings |
This allows you to adjust the burn setting. Higher is darker. Not all printer types allow this. |
Tag Printer Make & Model |
The make and model of the tag printer, e.g., Eltron_2742. |
Tag Sensor Mode |
The method by which the tag printer senses the start of the label. |
Tag Stop Position |
Millimeters to advance the tag printer after printing, to be pulled back before the next tag begins. Applies to Zip Tape only. |
Top Edge Adjustment |
Allows you to adjust the space to the top. |